Do you know how to repair the rubber liner of a nylon ball mill
Because of water treatment involves acids and alkalis, most of the water treatment equipment is rubber linings. However, the rubber lining technology of many manufacturers is immature or due to improper use by users. Rubber linings may blister and delaminate after many years or months. As a result, the equipment cannot be used normally. The current repair method is that if the area is relatively small, it is appropriate to use a repair agent. If the area is relatively large, you can consider using a cold vulcanized rubber plate to repair it.
Repair method of epoxy resin:
Epoxy resin repair is an outdated repair method. In fact, epoxy repair is mainly a supplementary repair method, mainly used to solve small local repair methods due to bumps. However, because the repair technology was not mature at that time, it became rubber. One way of lining repair. However, with the improvement of rubber bonding technology and the shortcomings of epoxy resin to repair itself, he has been gradually eliminated by the market.
The disadvantages of rubber lining repair epoxy resin repair are as follows:
Because of rubber linings have been used on water treatment equipment for many years, some equipments are facing the middle and late life, and many equipment needs to be repaired. Some are repaired with epoxy resin, and poorly repaired epoxy resin layers are difficult to clean. It is important It is epoxy resin repair that also lost some of the characteristics of the original rubber, and the bonding strength and bonding strength with the original rubber can not meet the requirements of repair.
Face problems before cold vulcanization repair:The problems faced by cold bonding technology on site before are:
1. Insufficient bonding strength causes rubber to easily cause bubbling or falling off
2, after the site bonding is good, you need to wait for about 15 days before you can use it, the use cycle is too long
3. On-site cold-adhesive rubber and raw rubber cannot be bonded and leaks occur.
The above reasons are also the main reasons that most processing manufacturers believe that they cannot be completed on-site, but as the technology continues to mature, these difficulties have been resolved.
Company:Xinxiang Tongjia Industrial Equipment Technology Co., Ltd.
Phone:086+18568631888
Email:info@aballmill.com
WhatsApp:086+15138925611
